A universal roof hatch designed for use in any appropriate vehicle. Interior diameter of the hatch is approximately 30.5". Includes rubber seals to be water tight.

Simply cut a 30" hole in your existing roof system, put sealant on the roof, and then use the included fasteners to clamp it down to the roof in a similar fashion to how bed caps are installed on trucks.

Can fit between A and B pillar, B and C pillar, or in the rear of a wagon. Hatch weighs approximately 30 lbs. Depending on your roof structure, you might not need any additional support.

Pictures show the Mk2 hatch. The actual product will likely evolve as production continues to increase durability and performance AND reduce cost.

Currently available in raw aluminum finish. Finish options are possible and will be added as time goes on.

This is not a stocked item. Estimated time until shipping is 4 weeks.

* Intended for off road use only in vehicles with adequate roof structures AFTER installation.